IMOD – Remainder after integer division

Block SymbolLicensing group: STANDARD

Function Description
The IMOD block divides two integer input signals, $n = i1 % i2$ , where $%$ stands for remainder after integer division operator (modulo). If both numbers are positive and the divisor is greater than one, the result is either zero (for commensurable numbers) or a positive integer lower than the divisor. In the case that one of the numbers is negative, the result has the sign of the dividend, e.g. $15 % 10 = 5$ , $15 % (- 10) = 5$ , but $(- 15) % 10 = - 5$ . In case $i2 = 0$ , the output $E$ is set to on and the output $n$ is substituted by $n = nerr$ .

Inputs

i1	First integer input of the block $↓$ -9.22E+18 $↑$ 9.22E+18	Long (I32)
i2	Second integer input of the block $↓$ -9.22E+18 $↑$ 9.22E+18	Long (I32)

Outputs

n	Remainder after integer division	Long (I32)
E	Error flag – division by zero	Bool

Parameters

vtype	Numeric type $⊙$ 4	Long (I32)
	2 .... Byte 3 .... Short 4 .... Long 5 .... Word 6 .... DWord 10 ... Large
nerr	Substitute value for an error case $⊙$ 1	Long (I32)

[Previous] [Back to top] [Up] [Next]