OUTRQUAD, OUTROCT, OUTRHEXD – Multi-output blocks with verification

Block SymbolsLicensing group: ADVANCED

Function Description
The OUTRQUAD, OUTROCT and OUTRHEXD blocks allow simultaneous writing of multiple signals, they are similar to the OUTQUAD, OUTOCT and OUTHEXD blocks. Additionally they provide feedback information about the result of write operation for the given output.

There are two ways to inform the control algorithm about the result of write operation through the raw $i$ output:

Through the value of the output, which can e.g. contain the real bit value in case of exceeding the limits of D/A converter (thus the raw notation).
Through reading the quality flags of the signal. This information can be separated from the signal by the VIN and QFD blocks.

The raw $i$ outputs are not always refreshed right at the moment of block execution, there is some delay given by the properties of the driver, communication line and/or target platform.

Inputs

val $i$	Output signals defined by the control algorithm through the input/output driver. The type and location of individual signals is described in the user manual for the given driver.	Unknown

Outputs

raw $i$	Feedback information about the write operation result. The type and meaning of individual signals is described in the user manual for the given driver.	Unknown

[Previous] [Back to top] [Up] [Next]