SHIFTOCT – Data shift register

Block SymbolLicensing group: STANDARD

Function Description

The SHIFTOCT block works as a shift register with eight outputs of arbitrary data type.

If the RUN input is active, the following assignment is performed with each algorithm tick:

\begin{array}{rcl} y_{i} & = & y_{i - 1}, i = 1 . . 7 \\ y0 & = & u \end{array}

Thus the value on each output y0 to y6 is shifted to the following output and the value on input u is assigned to output y0.

The block works with any data type of signal connected to the input u. Data type has to be specified by the vtype parameter. Outputs y0 to y8 then have the same data type.

If you need a triggered shift register, place the EDGE_ block in front of the RUN input.

Inputs

u	Data input of the register	Unknown
RUN	Enables outputs shift	Bool

Outputs

y0	First output of the block	Unknown
y1	Second output of the block	Unknown
y2	Third output of the block	Unknown
y3	Fourth output of the block	Unknown
y4	Fifth output of the block	Unknown
y5	Sixth output of the block	Unknown
y6	Seventh output of the block	Unknown
y7	Eighth output of the block	Unknown

Parameters

vtype

Output data type $⊙$ 8

Long (I32)

1 ....: Bool
2 ....: Byte (U8)
3 ....: Short (I16)
4 ....: Long (I32)
5 ....: Word (U16)
6 ....: DWord (U32)
7 ....: Float (F32)
8 ....: Double (F64)
–- ...
10 ...: Large (I64)

[Previous] [Back to top] [Up] [Next]