SWU – Switch unit

Block SymbolLicensing group: STANDARD

Function Description
The SWU block is used to select the appropriate signal which should be tracked by the inactive PIDU and MCU units in complex control structures. The input signal uc is copied to the output y when all the binary inputs OR1, …, OR4 are off, otherwise the output y takes over the uo input signal.

Inputs

uc	This input is copied to output y when all the binary inputs OR1, OR2, OR3 and OR4 are off	Double (F64)
uo	This input is copied to output y when any of the binary inputs OR1, OR2, OR3, OR4 is on	Double (F64)
OR1	First logical output of the block	Bool
OR2	Second logical output of the block	Bool
OR3	Third logical output of the block	Bool
OR4	Fourth logical output of the block	Bool

Output

y	Analog output of the block	Double (F64)

[Previous] [Back to top] [Up] [Next]